Remove lower cover and drain by opening the pump filter.
He2 plus washer door locked.
Remove the lower front panel from the front of the washer by removing the 3 screws in the bottom of it.
Check the drain pump filter for foreign objects.
This may reset the door lock it will release the door too.
Check the two ground switches are pressed correctly by the toe and rear panels.
Disconnect the power cord from the power source.
Then pull the door open.
Check for foreign objects in the door lock receiver.
If door is locked drain the unit.
If the door lock receiver is clear check the wire harness connections between the door lock switch assembly and the main electronic control board.
Remove the lower toe panel by removing the screws along the bottom edge.
Carefully reach up the inside of the front panel and pull the release tab on the bottom of the door lock assembly.
Timer does not decrement water does not enter.
Reach up behind the front panel and pull down on a pull ring that is attached to the bottom of the door lock mechanism to manually unlock the door.
Press stop a few times and add garment blink read more.
Remove the bottom front service panel as shown in the first image below.
Pull the door open.
To manually unlock and open the door remove the bottom front service panel reach up into the cabinet and pull down on the manual release tab on the bottom of the door lock switch assembly.
Kenmore he2 frontload washer.
Plug in washer or reconnect power.
Start cycle causes door to lock but then nothing more.
Then reach inside the washer by the door lock and pull the manual release tab on the bottom of the lock.
Check all the green wires ground harnesses system are notbroken or wires detached.
Ok check the door switch lock unit running the drain cycle.