I did a search and most post are about the jacks.
Happy jack bed lift problems.
Remove the motor plug from the pnp control module release the brake lever on the end of the motor if beds are up they will drift downward.
It just quit on me so i figured i had blown a fuse.
All fuses checked out ok.
Unplug the motor 2.
Happijac s power lift can accommodate one reversible sofa or a sofa single bunk.
Unplug the motor 2.
Generally no more than 4 6 inches.
Looking for some help advice regarding my happijac electric bed and it s wiring configuration.
Release the brake 3.
Position the bed s well out of the upper lower limit switches if possible.
Be careful not to get camper very far out of level.
Bed lift the brake must be released and the motor unplugged.
Your happijac experience is important to us.
I m trouble shooting an up raising problem with the beds currently and need to locate the circuit board for the system.
Emergency manual operation to manually lower the beds.
Because the weight of the camper is not the same at all four corners the jacks will not raise and lower at the same speed.
I lifted my camper off the truck and was in the process of lowering it.
All up press and hold button 6 and all 4 jacks extend to raise the camper.
How can we help you.
Bed will slowly drift downward.
Happijac s power bed lift supports up to two queen size beds in an innovative patented double bunk bed configuration.
If not exercise extreme caution during the following steps to avoid damage to the system.
All down press and hold button 5 and all 4 jacks retract to lower the camper.
Happijac bed lift leg support bracket installation.
Re apply brake at desired bed height.
Apply downward pressure to the bed platform.
Beds can be raised out of the way to make room for atvs or other equipment and lowered again when needed.
From bed lifts and slide outs to tie downs jacks and toolboxes we have a solution for many of your rv needs.
Happijac bed lift dual support leg installation.
Fj60kai on 03 16 12 11 53am hello folks new member here.
My problem seems to be with the remote.
